My Light Diagram

IC 555 timer tester is a simple circuit that serves to test the condition of IC 555. 555 timer circuit tester, in principle, start the timer 555 in astable multivibrator mode. As an indicator of the status of the timer 555 good condition or damaged to use 2 pieces LED which will light up in a blink alternately when the timer 555 in good condition.  And only one will turn on or off all the timer 555 when the condition is broken. 555 timer circuit tester is powered using 9 Volt DC voltage source. Complete circuit tester 555 as follows. Tester schematic How to use 555 timer tester is in conjuction with IC 555 to test the existing IC socket according to the orderbutton. Then activate the power switch to begin testing the 555 timer ic. Then live we observe the LED indicators 2buah before, whether flashing alternately (good) or not blink or even die all (timer 555 damaged).

This class-D audio ability amplifier is acceptable for TV and home stereo set. TDA7882 IC dent provides class-D audio ability amplifier solution. Since this dent has alone address channel, you charge two pieces of this ambit for stereo application. The ability accumulation voltage is flexible, acquire (+-)10V to (+-)25V. This ambit needs a breach accumulation (symmetric ability supply). Here are the capital appearance of this class-D amplifier: 25W OUTPUT POWER: RL = 8 ohm/4 ohm; THD = 10% HIGH EFFICIENCY WIDE SUPPLY VOLTAGE RANGE (UP TO ±25V) SPLIT SUPPLY OVER-VOLTAGE PROTECTION ST-BY AND MUTE FEATURES SHORT CIRCUIT PROTECTION THERMAL OVERLOAD PROTECTION

This schematic diagram show a single chip Theremin circuit.  Theremin is an electronic music instrument which sense hand movement to control the tones/frequency.  This Theremin circuit uses two separate Colpitts LC oscillators to produce a beat frequency.  The frequencies of  two Colpitts LC oscillators are mixed and then rectified. This rectification  demodulate the mixed signal to get the beat frequency which is in audible range. This beat frequency or difference is the real  Theremin’s output. The oscillator is operated at high frequency (inaudible) to get wide audible frequency range of beat frequency when two oscillator output is mixed.  This circuit uses a 4011 quad gate to construct the high frequency oscillator operating at 250kHz. Here is the schematic diagram of the circuit. Single Chip Theremin Circuit Diagram The metal probe that is used to sense your  hand produces only small frequency shift in term of percentage of original frequency...